0 Cart

Product filters

In Stock
Price

$  –  $

  • $7
  • $700
Receiver Thickness

Receiver Flats

AK-Builder Flat

Our receiver flats have been the standard go-to flats for years.  All flats are made with 4130 steel for the best results for heat treating.

Top Rail Fit

$46.95
With Y & I Embossing, 1mm
The front and rear trunnion holes on these flats are pre-punched to help with the installation of the trunnions.  In some cases the front trunnion...
In Stock
 

$44.95
With Y & I Embossing, 1mm
Now with Y & I embossing! These flats can be used for about any 1mm thick 7.62 receiver.  Without the trunnion holes you can put any rear...
In Stock
 

$7.00
These are made from heat treated 4130 steel and the rivets are a copy of an original AK center support rivet. The length is shorter than the 1mm center...
In Stock

$45.95
With Y & I Embossing, 1mm
This flat has the magwell and mag dimples to match the 5.45 magazines which are narrower then 7.62 mags.  There are no front or rear trunnion holes....
In Stock
 

$59.95
With Y & I Embossing, 1mm
The Polish Underfolder is the most popular underfolder parts kit and this was the first specialty flat that I had perfected by modifying existing flats in...
In Stock
 

$59.95
With Y & I Embossing, 1mm
These are the correct flats for the AMD-65 parts kits with the sidefolding stock.  These do not need the sidefolder reinforcement plate.  The...
In Stock
 

$14.95
These new plates have been made from the dimensions of original demilled Russian and Bulgarian plates. This plate welds to the rear lower section of...
In Stock

$14.95
This is a new design that matches the original plates.  Orders shipped after 9/5/2015 will have the newer design. These are not needed on the Yugo's...
In Stock