Receiver Flats

AK-Builder Flat

The front of the receiver is trimmed out far enough to allow the trunnion to just slide in without trimming unlike the other flats that are on the market.  Theirs are stamped and need the flange to be a certain length to be bent.  My top rails are CNC machined to look like the original receivers.

Top Rail Fit

$7.00
These are made from heat treated 4130 steel and the rivets are a copy of an original AK center support rivet. The length is shorter than the 1mm center...
In Stock
+
Add to wish list

$8.95
Get a set of the best US made rails available! These have mag stabilizers on both rails unlike any other rails made in the US.There are no holes drilled in...
In Stock
+
Add to wish list

$9.95
Trunnion shim for fitting a Yugo M70 rear trunnion into an M92/M70 flat trunnion receiver. Made from .025" thick steel and comes in pairs to shim each side...
In Stock
+
Add to wish list

$10.00
This is a new design that matches the original plates.  Orders shipped after 9/5/2015 will have the newer design. These are not needed on the Yugo's...
In Stock
+
Add to wish list

$10.00
Thesw new plates have been made from the dimensions of original demilled Russian and Bulgarian plates. This plate welds to the rear lower section of...
In Stock
+
Add to wish list

$19.95 $10.95
1mm
These flats have the top rails bent, but the the die we used to do the step went bad and now we are offering them up at a discounted price.  THESE...

$21.95 $17.95
This is for the longer Russian pistol grip to fit on the Saiga 12.  The Hogue pistol grip is longer than standard and uses this same plate. Pistol grip and...
In Stock
+
Add to wish list

$25.95
1mm
Now with Y & I embossing! These flats can be used for about any 1mm thick 7.62 receiver.  Without the trunnion holes you can put any rear...
In Stock
+
Add to wish list

$28.95 $25.95
1mm
This flat has the magwell and mag dimples to match the 5.45 magazines which are narrower then 7.62 mags.  There are no front or rear trunnion holes....
In Stock
+
Add to wish list

$26.95
1mm
The front and rear trunnion holes on these flats are pre-punched to help with the installation of the trunnions.  In some cases the front trunnion rivet...
In Stock
+
Add to wish list

$29.95
1.27mm
This is our MAK90 flat without trunnion holes with the top rails machined.  Due to the dimensional differences between these and the other flats you will...
In Stock
+
Add to wish list

$29.95
1.27mm
This is our MAK90 flat with trunnion holes and the top rails machined.  Due to the dimensional differences between these and the other flats you will...
Out-of-stock Add to wish list