Receiver Flats

AK-Builder Flat

The front of the receiver is trimmed out far enough to allow the trunnion to just slide in without trimming unlike the other flats that are on the market.  Theirs are stamped and need the flange to be a certain length to be bent.  My top rails are CNC machined to look like the original receivers.

Top Rail Fit

$34.95
THIS REQUIRES OUR MODIFIED MAK90 PUNCH TO BEND CORRECTLY. IF YOU USE OUR OLD PUNCH IT WILL RUIN THE FLAT! WE HAD TO MODIFY THE MAK90 PUNCH TO ACCOMADATE...
Out-of-stock Add to wish list

$29.95
1.27mm
This is our MAK90 underfolder flat with top rails machined and mag well dimples. These come with lower bolt guide rails. Due to the dimensional...
Out-of-stock Add to wish list

$32.95
1.27mm
This is our MAK90 flat with top rails machined and mag well dimples. These come with lower bolt guide rails. Due to the dimensional differences between...
Out-of-stock Add to wish list

$8.95
Get a set of the best US made rails available! These have mag stabilizers on both rails unlike any other rails made in the US.There are no holes drilled in...
In Stock
+
Add to wish list

$37.50
1.5mm
Finally there is an alternative to the home builder to make your own professional grade 1.5mm receiver from a flat. The material these are made from is .063...
In Stock
+
Add to wish list

$10.00
Thesw new plates have been made from the dimensions of original demilled Russian and Bulgarian plates. This plate welds to the rear lower section of...
In Stock
+
Add to wish list

$19.95 $10.95
1mm
These flats have the top rails bent, but the the die we used to do the step went bad and now we are offering them up at a discounted price.  THESE...

$29.95
1.27mm
This is our MAK90 flat without trunnion holes with the top rails machined.  Due to the dimensional differences between these and the other flats you will...
In Stock
+
Add to wish list

$29.95
1.27mm
This is our MAK90 flat with trunnion holes and the top rails machined.  Due to the dimensional differences between these and the other flats you will...
Out-of-stock Add to wish list

$37.50
1.5mm
This is the 1.5mm 4130 flat and rails for the M85 kits that are out.  It's basically just our standard M70 underfolder flat without the pin holes cut for...
In Stock
+
Add to wish list

$21.95 $17.95
This is for the longer Russian pistol grip to fit on the Saiga 12.  The Hogue pistol grip is longer than standard and uses this same plate. Pistol grip and...
In Stock
+
Add to wish list

$38.50
1.5mm
These flats are for the bulged trunnion RPK 47 7.62 parts kits.  The flats and rails are made from 4130 and are in the soft annealed condition and need to...
In Stock
+
Add to wish list