Receiver Flats

AK-Builder Flat

The front of the receiver is trimmed out far enough to allow the trunnion to just slide in without trimming unlike the other flats that are on the market.  Theirs are stamped and need the flange to be a certain length to be bent.  My top rails are CNC machined to look like the original receivers.

Top Rail Fit

$35.00 $34.95
1mm
These are the correct flats for the AMD-65 parts kits with the sidefolding stock.  These do not need the sidefolder reinforcement plate.  The holes on the...
In Stock
+
Add to wish list

$35.00 $34.95
1mm
The Polish Underfolder is the most popular underfolder parts kit and this was the first specialty flat that I had perfected by modifying existing flats in...
In Stock
+
Add to wish list

$26.95
1mm
The front and rear trunnion holes on these flats are pre-punched to help with the installation of the trunnions.  In some cases the front trunnion rivet...
In Stock
+
Add to wish list

$25.95
1mm
Now with Y & I embossing! These flats can be used for about any 1mm thick 7.62 receiver.  Without the trunnion holes you can put any rear...
In Stock
+
Add to wish list

$28.95 $25.95
1mm
This flat has the magwell and mag dimples to match the 5.45 magazines which are narrower then 7.62 mags.  There are no front or rear trunnion holes....
In Stock
+
Add to wish list

$37.50 $34.95
1mm
This flat was made for the Bulgarian style sidefolding triangle or polymer stock.  The magwell and magwell dimples are made to fit 5.45 magazines.  If you...
In Stock
+
Add to wish list

$35.00 $34.95
1mm
This flat will work with the M92 or M70 that has the flat sided front trunnion . These will NOT WORK with the bulged RPK style trunnions.   There...
In Stock
+
Add to wish list

$10.00
This is a new design that matches the original plates.  Orders shipped after 9/5/2015 will have the newer design. These are not needed on the Yugo's...
In Stock
+
Add to wish list

$35.00 $34.95
1mm
THESE DO NOT HAVE ALIGNMENT HOLES IN THEM ANYMORE The AMMS trunnions I have seen are machined unlike the Polish which are stamped and welded...
Out-of-stock Add to wish list

$35.00 $34.95
1mm
This flat is specifially made for the Polish Tantal to work with the left side selector and right side safety.  The hole for the selector/safety is a...
Out-of-stock Add to wish list

$34.95
1mm
    These are made to work with the Romanian underfolder stocks and will not work with the Polish or Yugo sets.  There is no need to buy a...
In Stock
+
Add to wish list

$9.95
Trunnion shim for fitting a Yugo M70 rear trunnion into an M92/M70 flat trunnion receiver. Made from .025" thick steel and comes in pairs to shim each side...
In Stock
+
Add to wish list