0 Cart

Hardened Trigger Guard Rivet Drilling Jig

A3-41
In Stock
$29.95
Add to wish list
HARDENED TRIGGER GUARD RIVET DRILLING JIG, A3-41

Hardened Trigger Guard Rivet Drilling Jig

$29.95

Here is a tool that I made up a few years ago for drilling out the trigger guard rivets. This block clamps to your trigger guard and allows you to drill directly through the center of the rivets. I've even used this to drill out front trunnion rivets by using a bar clamp to hold it in place. Made of heat treated steel and comes with the drill bit as shown.

$37.95
This tool is made for removing the trunnion rivets off of parts kits or removing rivets that we sell.  Made of steel then heat treated for wear...
B6-31
In Stock

$2.95
These are the same drills I use in the Rivet Drilling tool, drilling gas piston rivet holes and for drilling holes for the 4mm rivet holes in receivers....
C1-72

$85.00
This jig will install the five trigger guard rivets. The front four rivets can be set at once and the rear will be done separately. There is a magnet that...
T1-11
In Stock

$99.95
Here is a professional tool for drilling the front and rear trunnion holes in AK47 receivers.  This tool will work with 7.62 and 5.45 trunnions...
T3-11
In Stock

  • Out of stock
AK-Builder Rivet Tool
$270.00
THIS WILL INSTALL THE FRONT/REAR TRUNNION RIVETS AND CENTER SUPPORTS .  It will not install the trigger guard rivets. Are you ready for a...
T5-11
No products with the selected options in stock

No reviews found