0 Cart

Yugo M70 1.5mm Yugo Fixed Stock Flat

B3-11
In Stock
$57.50
Add to wish list
YUGO M70 1.5MM YUGO FIXED STOCK FLAT, B3-11

Yugo M70 1.5mm Yugo Fixed Stock Flat

$57.50

Finally there is an alternative to the home builder to make your own professional grade 1.5mm receiver from a flat. 

The material these are made from is .063 4130 Chromoly steel that is in the annealed condition.  Yes annealed means it needs to be heat treated.  Yes the flats come with rails as always and both are made from annealed 4130 and are .050" thick.  The mag stabilizers/guides need to be trimmed just like all of my other rails.

There are no front trunnion holes drilled and the hammer, trigger and center support holes need to be drilled also.  This is to allow you to make the receiver like it should be done to be as perfect as possible.  Holes that are too close to a bend will stretch which is bad for the trigger pin holes.

 

 

This item is made in the United States and counts as a 922r compliant part.

Receiver Thickness:
1.5mm
$37.95
This tool is made for removing the trunnion rivets off of parts kits or removing rivets that we sell.  Made of steel then heat treated for wear...
B6-31
In Stock

$270.00
THIS WILL INSTALL THE FRONT/REAR TRUNNION RIVETS AND CENTER SUPPORTS .  It will not install the trigger guard rivets. Are you ready for a...
T5-11
In Stock

$14.00
PSL/FPK
The new long rear trunnion rivets have a slightly shorter head and the cupped tool that supports the rivets will need to be sanded down to keep the...
A0-11
In Stock
 

No reviews found