ak-builder.comDo to the upcoming holiday, no one will be in the office on Thursday the 23rd or Friday the 24th.

Yugo M70 1.5mm Yugo Underfolder Flat

Brand:
$37.50
B3-31
In Stock
+
Add to wish list

Finally there is an alternative to the home builder to make your own professional grade 1.5mm receiver from a flat. The material these are made from is .063 4130 Chromoly steel that is in the annealed condition. Yes annealed means it needs to be heat treated. Yes the flats come with rails as always and both are made from annealed 4130 and are .050" thick. The mag stabilizers/guides need to be trimmed just like all of my other rails. There are no front trunnion holes drilled and the hammer, trigger and center support holes need to be drilled also. This is to allow you to make the receiver like it should be done to be as perfect as possible. Holes that are too close to a bend will stretch which is bad for the trigger pin holes.

THIS IS NOT FOR THE M85

 

 

This item is made in the United States and counts as a 922r compliant part.

B6-31
$27.95
This tool is made for removing the trunnion rivets off of parts kits or removing rivets that we sell.  Made of steel then heat treated for wear...
In Stock
+
Add to wish list

RIVET-TOOL
$270.00
THIS WILL INSTALL THE FRONT/REAR TRUNNION RIVETS AND CENTER SUPPORTS .  It will not install the trigger guard rivets. Are you ready for a...
In Stock
+
Add to wish list

AKB-RS
$9.00
The new long rear trunnion rivets have a slightly shorter head and the cupped tool that supports the rivets will need to be sanded down to keep the tool...
In Stock
+
Add to wish list

C8-51
$7.00
These are made from heat treated 4130 steel and the rivets are a copy of an original AK center support rivet. The length is shorter than the 1mm center...
In Stock
+
Add to wish list