ak-builder.com

AMD65 Rifle Parts Kit 12.5" Barrel

Brand:
$459.95
Kit-12nc
In Stock
+
Add to wish list

This AMD65 kit has the original length barrel which we machined in house.  For this to be built as a rifle you need to use a barrel extension or it can be built as-is for an SBR.  Make sure to follow all NFA rules when using this kit with the shorter barrel.

The barrel is 12.5" long and is made in the USA and marked U.S.A. 7.62.

Keep in mind these kits are sold as is as far as furniture and finish are concerned. 

Ok, now that that is done here is what we've done...

All journals are measured as well as the parts to be pressed to make sure the fit is correct.  We set the headspace and check it twice with a GO gauge, with a live round (not fired just for testing the bolt closing) then with a NO-GO gauge.  After setting the headspace we drill the barrel pin hole and ream for the new barrel pin.  The pin is pressed most of the way through so you can press it back out the same way it was put in to remove the barrel for installing rivets.  If you don't want to use rivets then just press the barrel pin the rest of the way in.

The rear sight, gas block and front sight are pressed on after the barrel pin is installed to make sure everything fits correctly on the barrel.  We use a special fixture to press on each piece to ensure proper alignment.

When reinstalling the barrel I reccommend to use a headspace gauge again to make sure you install it back to the original setting.

I1-11
$169.95
The base of this die set is made from a solid piece of steel that starts off at 17lbs and is machined to 14.5lbs.  There is a radius at the entrance of the...
In Stock
+
Add to wish list

C4-51
$40.00 $29.95
Extended AMD 65 Muzzle Brake 4.3" long/ 7.1 oz.  is made from 4140 steel to bring the barrel length of the rifle to 16".  Threads are 14-1 left hand.  These...
In Stock
+
Add to wish list

A2-53
$17.50
Made from stainless steel then heat treated. The only other AMD 65 pistons on the market are softer non-heat treated ones. Comes with rivet for...
In Stock
+
Add to wish list

AKB-RS
$9.00
The new long rear trunnion rivets have a slightly shorter head and the cupped tool that supports the rivets will need to be sanded down to keep the tool...
In Stock
+
Add to wish list

A1-31
$7.00
These center supports will be less prone to crushing unlike other center supports made from steel tubing. There is nothing worse than having the center...
In Stock
+
Add to wish list

B1-61
$35.00
These are the correct flats for the AMD-65 parts kits with the sidefolding stock.  These do not need the sidefolder reinforcement plate.  The holes on the...
In Stock
+
Add to wish list