ak-builder.com
 

Bent Polish Receiver Blank Kit AK47 7.62x39 - 80% Complete

Brand:
$37.95
H1-21
In Stock
+
Add to wish list

NEW Bent Polish Receiver Blanks Kit - 80% Complete

THESE ARE NOT HEAT TREATED

Made from 8620 Steel.

Just because this was made in Poland doesn't mean it will only work with a Polish AK kit.  It will work with any AK47 1mm stamped parts kit as long as the correct holes are drilled.  You can make it a Romanian fixed stock, Polish Underfolder, Romanian Underfolder, Kyber Pass, Maadi, AMD65, AMD63, M92 or anything that has a 7.62 magwell on a 1mm receiver.

NO FFL NEEDED - Approved by the ATF as a NON-FIREARM

Includes:

A1-31  AK Center Support for 1mm Receivers

AK-Builder Lower Rails

 

V-4
$99.95
AK-BUILDER Receiver Blank Drilling Fixture This tool is designed to be used with 1mm 80% receivers with OR without rails and center supports...
In Stock
+
Add to wish list

H1-31
$24.95
NEW Bent Polish Receiver Blanks - 80% Complete ( DOES NOT INCLUDE CENTER SUPPORT & RAILS) THESE ARE NOT HEAT TREATED Made from 8620...
In Stock
+
Add to wish list

B6-31
$27.95
This tool is made for removing the trunnion rivets off of parts kits or removing rivets that we sell.  Made of steel then heat treated for wear...
In Stock
+
Add to wish list

RIVET-TOOL
$270.00
THIS WILL INSTALL THE FRONT/REAR TRUNNION RIVETS AND CENTER SUPPORTS .  It will not install the trigger guard rivets. Are you ready for a...
In Stock
+
Add to wish list

AKB-RS
$9.00
The new long rear trunnion rivets have a slightly shorter head and the cupped tool that supports the rivets will need to be sanded down to keep the tool...
In Stock
+
Add to wish list