ak-builder.com

Khyber Pass AK-47 Parts Kit 16" 7.62 x 39

Brand:
$579.95
Kit-4nc
In Stock
+
Add to wish list

This kit comes with our newly made triangle sidefolding stock.

The hole for the latch will need to be drilled in the front trunnion which is shown in the installation guide for the stock.  The barrel is available as non-chromed, chromed and nitrided and the kits will be non-maching serial numbers.

This is a parts kit that was bought and we installed a new US made barrel.  Keep in mind these kits are sold as is as far as furniture and finish are concerned.  I don't get to cherry pick the kits when we order them and I can't guarantee anything other than all of the parts except for the triggers will be included.  I know one of the kits we have was missing a hammer and disconnector so I will assume they will all be missing the triggers.  I will make sure all other parts that normally don't get swapped out for 922r parts are still there.

Ok, now that that is done here is what we've done...

All journals are measured as well as the parts to be pressed to make sure the fit is correct.  We set the headspace and check it twice with a GO gauge, with a live round (not fired just for testing the bolt closing) then with a NO-GO gauge.  After setting the headspace we drill the barrel pin hole and ream for the new barrel pin.  The pin is pressed most of the way through so you can press it back out the same way it was put in to remove the barrel for installing rivets.  If you don't want to use rivets then just press the barrel pin the rest of the way in.

The rear sight, gas block and front sight are pressed on after the barrel pin is installed to make sure everything fits correctly on the barrel.  We use a special fixture to press on each piece to ensure proper alignment.

When reinstalling the barrel I reccommend to use a headspace gauge again to make sure you install it back to the original setting. This kit uses AKS Underfolder rivet set, sold seperately

The parts kits come with just the main parts, no rivets, no center support, no receiver flat, no rails and no tools.

 

A1-31
$7.00
These center supports will be less prone to crushing unlike other center supports made from steel tubing. There is nothing worse than having the center...
In Stock
+
Add to wish list

AKB-RS
$9.00
The new long rear trunnion rivets have a slightly shorter head and the cupped tool that supports the rivets will need to be sanded down to keep the tool...
In Stock
+
Add to wish list

B6-41
$10.00
NEW DESIGN as of 8/13/2015 The new plates have been made from the dimensions of original demilled Russian and Bulgarian plates. This plate...
In Stock
+
Add to wish list

B2-31
$37.50 $35.00
T h is flat is for using a Bulgarian style rear sidefolding stock/trunnion to make the so called "Khyber Pass" AK's in 7.62x39. Receiver flat...
In Stock
+
Add to wish list