ak-builder.com
 

Polish 7.62x39 Fixed Stock Parts Kit with Headspaced New 16" US Barrel

Brand:
$548.95
+
Add to wish list

This is a parts kit that was bought and we installed a new US made barrel.  Keep in mind these kits are sold as is as far as furniture and finish are concerned. The barrel is threaded 14-1 lh.

Ok, now that that is done here is what we've done...

All journals are measured as well as the parts to be pressed to make sure the fit is correct.  We set the headspace and check it twice with a GO gauge, with a live round (not fired just for testing the bolt closing) then with a NO-GO gauge.  After setting the headspace we drill the barrel pin hole and ream for the new barrel pin.  The pin is pressed most of the way through so you can press it back out the same way it was put in to remove the barrel for installing rivets.  If you don't want to use rivets then just press the barrel pin the rest of the way in.

The rear sight, gas block and front sight are pressed on after the barrel pin is installed to make sure everything fits correctly on the barrel.  We use a special fixture to press on each piece to ensure proper alignment.

When reinstalling the barrel I reccommend to use a headspace gauge again to make sure you install it back to the original setting. 

The parts kits come with just the main parts, no rivets, no center support, no receiver flat, no rails and no tools.

B2-61
$29.95
1mm
The front and rear trunnion holes on these flats are pre-punched to help with the installation of the trunnions.  In some cases the front trunnion rivet...

B1-71
$24.95
1mm
Now available with Y & I embossing! These flats can be used for about any 1mm thick 7.62 receiver.  Without the trunnion holes you can put any...
No products with the selected options in stock Add to wish list

AKB-RS
$9.00
The new long rear trunnion rivets have a slightly shorter head and the cupped tool that supports the rivets will need to be sanded down to keep the tool...
+
Add to wish list

A1-31
$7.00
These center supports will be less prone to crushing unlike other center supports made from steel tubing. There is nothing worse than having the center...
In Stock
+
Add to wish list