Russian TULA Krink Parts Kit

We now have RARE Russian TULA Krinkov kits! However we only have a limited supply of these kits so get them while you can!!
Keep in mind these kits are sold as is as far as furniture and finish are concerned. 
Ok, now that that is done here is what we've done...
All journals are measured as well as the parts to be pressed to make sure the fit is correct.  We set the headspace and check it twice with a GO gauge, with a live round (not fired just for testing the bolt closing) then with a NO-GO gauge.  After setting the headspace we drill the barrel pin hole and ream for the new barrel pin.  The pin is pressed most of the way through so you can press it back out the same way it was put in to remove the barrel for installing rivets.  If you don't want to use rivets then just press the barrel pin the rest of the way in.
The rear sight, gas block and front sight are pressed on after the barrel pin is installed to make sure everything fits correctly on the barrel.  We use a special fixture to press on each piece to ensure proper alignment.
When reinstalling the barrel I reccommend to use a headspace gauge again to make sure you install it back to the original setting.
All numbers match on these kits except the bolt.
These have K-Var gas pistons.
These kits come with CHROME LINED barrels ONLY.
Russian TULA 5.45 Plum 30rd Magazine. Has the Russian TULA star mark on the side of the magazine.   Used mags will show minor wear and all...
In Stock
Add to wish list

$37.50 $35.00
This flat was made for the Bulgarian style sidefolding triangle or polymer stock.  The magwell and magwell dimples are made to fit 5.45 magazines.  If you...
In Stock
Add to wish list

All US made Krinkov 4 Piece flash hiders are made of 4130 steel and the cone is nickel plated inside and out. The main body and cap are phosphated black....
In Stock
Add to wish list