ak-builder.com

Yugo M72 RPK Parts Kit 7.62 With Headspaced US Barrel

Brand:
$649.95
Kit-35n
In Stock
+
Add to wish list

Numbers match on all parts except for recoil spring assembly and have no numbers on trunnion. The model, year and numbers are missing on the trunnion. 

Comes with either a nitrided or chrome lined barrel choose the option when adding to the cart.

Comes with cleaning rod and cleaning kit.

 

Keep in mind these kits are sold as is as far as furniture and finish are concerned. 

Ok, now that that is done here is what we've done...

All journals are measured as well as the parts to be pressed to make sure the fit is correct.  We set the headspace and check it twice with a GO gauge, with a live round (not fired just for testing the bolt closing) then with a NO-GO gauge.  After setting the headspace we drill the barrel pin hole and ream for the new barrel pin.  The pin is pressed most of the way through so you can press it back out the same way it was put in to remove the barrel for installing rivets.  If you don't want to use rivets then just press the barrel pin the rest of the way in.

The rear sight, gas block and front sight are pressed on after the barrel pin is installed to make sure everything fits correctly on the barrel.  We use a special fixture to press on each piece to ensure proper alignment.

When reinstalling the barrel I reccommend to use a headspace gauge again to make sure you install it back to the original setting.

C8-51
$7.00
These are made from heat treated 4130 steel and the rivets are a copy of an original AK center support rivet. The length is shorter than the 1mm center...
In Stock
+
Add to wish list

H2-31
$52.99 $44.95
This item is used on the Yugo M70B1 (also M72) with a collapsible stock and composite tube in place of the original wood buttstock. Counts as 1 U.S. 922r...
In Stock
+
Add to wish list

B3-21
$37.50
Finally there is an alternative to the home builder to make your own professional grade 1.5mm receiver from a flat. The material these are made from is .063...
In Stock
+
Add to wish list

J3-51
$29.95
This adapter will install into either a M70 or M72 Yugo fixed stock rear trunnion to adapt to any AR15 stock tube.  There is a set screw in the bottom...
In Stock
+
Add to wish list