ak-builder.comDo to the upcoming holiday, no one will be in the office on Thursday the 23rd or Friday the 24th.

11.5" AK Pistol Parts Kit 7.62x39 Nitrided Barrel

Brand:
$549.95
Kit-23N
In Stock
+
Add to wish list

We created this kit from a Hungarian AMMS 63 platform. Then populated a custom 11.5" nitride barrel to bring you this pistol kit with endless possibilities. This kit comes with a pistol rear trunnion.  We have cut down the gas tube and swapped out the gas piston for this particular setup. All Hungarian AKM furniture will work with these kits. Some minor modification however may need to be done to other furniture sets to make it fit. 

Also a great starter kit to build as an SBR or save the tax stamp money and pin a barrel extension to the muzzle to bring the barrel length out to 16. inches overall length. 

 

Nice condition kits, but the trunnion numbers do not match the rest of the parts that are numbered.

Due to the fact that parts kits come in from over seas in plastic bags stacked on each other we DO NOT guarantee the wood furniture condition.  The only thing we will do is make sure that it's not broken.

 

All journals are measured as well as the parts to be pressed to make sure the fit is correct.  We set the headspace and check it twice with a GO gauge, with a live round (not fired just for testing the bolt closing) then with a NO-GO gauge.  After setting the headspace we drill the barrel pin hole and ream for the new barrel pin.  The pin is pressed most of the way through so you can press it back out the same way it was put in to remove the barrel for installing rivets.  If you don't want to use rivets then just press the barrel pin the rest of the way in.

The rear sight, gas block and front sight are pressed on after the barrel pin is installed to make sure everything fits correctly on the barrel.  We use a special fixture to press on each piece to ensure proper alignment.

When reinstalling the barrel I recommend to use a headspace gauge again to make sure you install it back to the original setting.

The parts kits come with just the main parts, no rivets, no center support, no receiver flat, no rails and no tools.

 
 
 
 
G7-51
$44.95
Made in USA Aluminum 6061 barrel extension with 14-1 LH threads.  5.5" long and 1.180" in diameter with a .4" bore. Hard anodized black and laser...
In Stock
+
Add to wish list

H1-11
$184.95
This new manufactured stock was modeled off of the Bulgarian triangle series rifles. Length without trunnion is 9 1/4" The trunnion and latch pieces are...
Out-of-stock Add to wish list

K2-21
$154.95
The TimberSmith Brown Laminate Stock Set is designed to fit on the Romanian AK-47 variant. This set comes complete with an upper and lower handguard, a...
In Stock
+
Add to wish list

B1-71
$24.95
Now available with Y & I embossing! These flats can be used for about any 1mm thick 7.62 receiver.  Without the trunnion holes you can put any...
In Stock
+
Add to wish list