ak-builder.com

AKB 80% Milled 7.62 Underfolder Receiver for Stamped Parts Kits

Brand:
$359.95
T1-11
In Stock
+
Add to wish list
With the lack of milled parts kits in mind, we came up with a receiver to take your stamped parts kit to the next level.  Our 80% receivers are made from 4140 steel then heat treated to 42HRC.  Hungarian AMMS 63D parts kits are ideal for these receivers, but most all 1mm stamped 7.62 parts kits (except Chinese) will work as far as barrel population, bolt and carrier.  The underfolding holes in the receiver are limited to Hungarian Underfolder or Milled Bulgarian Underfolder stocks.  If building from a milled parts kit you will need to open up the gap between the ears on top of the front trunnion 0.085 of an inch for the rear sight block to fit.
 
Our receivers come with new heat treated cover plates for the hole in the back of the receiver and under the front trunnion.  They also come with an 1/8" x 1/4" alloy dowel pin for the selector stop.
 
BE SURE TO ORDER THE AK-BUILDER "MILLED RECEIVER DRILLING FIXTURE" FOR THE CORRECT HOLE PLACEMENT.
 
These do NOT come with a bullet guide.
 
This item is made in the United States and counts as a 922r compliant part.
I4-13
$97.95
AK-BUILDER Milled Receiver Drilling Fixture This tool is made specifically for the AK-BUILDER 80% Milled Receivers. We can not guarantee this fixture...
In Stock
+
Add to wish list

M-10
$44.95
Used Hungarian Underfolding Stock. (USED - Scratches and/or minor dents.) Includes parts for assembly to rifle as shown.  Rear trunnion is included as...
In Stock
+
Add to wish list

G1-11
$22.99
Bulgarian Bullet Guide, Fits to 7.62 cal,rivet NOT included.
Out-of-stock Add to wish list

$5.00
Milled Receiver includes seven 8mm rivets for the trigger guard Stamped receivers with no reinforcement plate come with four 8mm rivets and one 6mm...
In Stock
+
Add to wish list