Welcome to ak-builder.com!

Receiver Flats

AK-Builder Flat

The front of the receiver is trimmed out far enough to allow the trunnion to just slide in without trimming unlike the other flats that are on the market.  Theirs are stamped and need the flange to be a certain length to be bent.  My top rails are CNC machined to look like the original receivers.

Top Rail Fit

$14.95
These new plates have been made from the dimensions of original demilled Russian and Bulgarian plates. This plate welds to the rear lower section of...
In Stock
+
Add to wish list

$14.95
This is a new design that matches the original plates.  Orders shipped after 9/5/2015 will have the newer design. These are not needed on the Yugo's...
In Stock
+
Add to wish list

$59.95
With Y & I Embossing, 1mm
    These are made to work with the Romanian underfolder stocks and will not work with the Polish or Yugo sets.  There is no need to buy a...
 
Out-of-stock Add to wish list

$9.95
Trunnion shim for fitting a Yugo M70 rear trunnion into an M92/M70 flat trunnion receiver. Made from .025" thick steel and comes in pairs to shim each side...
In Stock
+
Add to wish list

$49.95
With Y & I Embossing, 1mm
This flat was made for the Bulgarian style sidefolding triangle or polymer stock.  The magwell and magwell dimples are made to fit 5.45 magazines.  If you...
In Stock
 

$59.95
With Y & I Embossing, 1mm
This flat will work with the M92 or M70 that has the flat sided front trunnion . These will NOT WORK with the bulged RPK style trunnions.   There...
In Stock