Receiver Flats

AK-Builder Flat

The front of the receiver is trimmed out far enough to allow the trunnion to just slide in without trimming unlike the other flats that are on the market.  Theirs are stamped and need the flange to be a certain length to be bent.  My top rails are CNC machined to look like the original receivers.

Top Rail Fit

$19.95 $10.95
1mm
These flats have the top rails bent, but the the die we used to do the step went bad and now we are offering them up at a discounted price.  THESE...

$10.00
This is a new design that matches the original plates.  Orders shipped after 9/5/2015 will have the newer design. These are not needed on the Yugo's...
In Stock
+
Add to wish list

$10.00
Thesw new plates have been made from the dimensions of original demilled Russian and Bulgarian plates. This plate welds to the rear lower section of...
In Stock
+
Add to wish list

$9.95
Trunnion shim for fitting a Yugo M70 rear trunnion into an M92/M70 flat trunnion receiver. Made from .025" thick steel and comes in pairs to shim each side...
In Stock
+
Add to wish list

$8.95
Get a set of the best US made rails available! These have mag stabilizers on both rails unlike any other rails made in the US.There are no holes drilled in...
In Stock
+
Add to wish list

$7.00
These are made from heat treated 4130 steel and the rivets are a copy of an original AK center support rivet. The length is shorter than the 1mm center...
In Stock
+
Add to wish list