Receiver Flats

AK-Builder Flat

The front of the receiver is trimmed out far enough to allow the trunnion to just slide in without trimming unlike the other flats that are on the market.  Theirs are stamped and need the flange to be a certain length to be bent.  My top rails are CNC machined to look like the original receivers.

Top Rail Fit

$14.95
These new plates have been made from the dimensions of original demilled Russian and Bulgarian plates. This plate welds to the rear lower section of...
In Stock
+

$14.95
This is a new design that matches the original plates.  Orders shipped after 9/5/2015 will have the newer design. These are not needed on the Yugo's...
In Stock
+

$57.50
1.5mm
Finally there is an alternative to the home builder to make your own professional grade 1.5mm receiver from a flat.  The material these are made from is...
In Stock
+

$57.50
1.5mm
Finally there is an alternative to the home builder to make your own professional grade 1.5mm receiver from a flat. The material these are made from is .063...
In Stock
+

$57.50
1.5mm
Finally there is an alternative to the home builder to make your own professional grade 1.5mm receiver from a flat. The material these are made from is .063...
In Stock
+

$57.50
1.5mm
This is the 1.5mm 4130 flat and rails for the M85 kits that are out.  It's basically just our standard M70 underfolder flat without the pin holes cut for...
In Stock
+