Welcome to ak-builder.com!

Receiver Flats

AK-Builder Flat

The front of the receiver is trimmed out far enough to allow the trunnion to just slide in without trimming unlike the other flats that are on the market.  Theirs are stamped and need the flange to be a certain length to be bent.  My top rails are CNC machined to look like the original receivers.

Top Rail Fit

$35.95
B1-11 Polish Tantal, 1mm
These flats have the top rails bent, but the the die we used to do the step went bad and now we are offering them up at a discounted price.  THESE...
In Stock
 

$58.95
THIS REQUIRES OUR MODIFIED MAK90 PUNCH TO BEND CORRECTLY. IF YOU USE OUR OLD PUNCH IT WILL RUIN THE FLAT! WE HAD TO MODIFY THE MAK90 PUNCH TO ACCOMADATE...
In Stock
+
Add to wish list

$54.95
1.27mm
This is our MAK90 flat with top rails machined and mag well dimples. These come with lower bolt guide rails. Due to the dimensional differences between...
In Stock
+
Add to wish list

$10.95
Get a set of the best US made rails available! These have mag stabilizers on both rails unlike any other rails made in the US.There are no holes drilled in...
In Stock
+
Add to wish list

$57.50
1.5mm
Finally there is an alternative to the home builder to make your own professional grade 1.5mm receiver from a flat. The material these are made from is .063...
In Stock
+
Add to wish list

$14.95
These new plates have been made from the dimensions of original demilled Russian and Bulgarian plates. This plate welds to the rear lower section of...
In Stock
+
Add to wish list