Drills and Taps

$4.95
These are the drill bits I use for drilling 7.62 gas ports.  These will fit into the port and it will guide the drill.  Just press the gas block on first....
In Stock
+

$32.45
 5mm and 7mm reamers for finishing the hammer and trigger holes on my flats. These will ensure that you have perfectly round holes for the axis pins to go...
In Stock
+

$5.25
US Made by Precision Twist Drill Screw Machine - Drills Size: 0.2756 In., 7.00 mm Flute Length: 1-11/32, 34 mm Overall Length: 2-29/32, 74 mm...
In Stock
+

$2.85
Material: HSS Screw Machine - Drills Size: 0.1181 In 3.00 mm Flute Length: 5/8, 16 mm Overall Length: 1-13/16, 46 mm Finish/Coating: Black...
In Stock
+

$2.95
These are the same drills I use in the Rivet Drilling tool, drilling gas piston rivet holes and for drilling holes for the 4mm rivet holes in receivers....
In Stock
+

$25.00
This is the same reamer we use to work with the .302 barrel pin holes.  Drill the hole first with a 7mm drill then ream the hole.  The reamer has more...
In Stock
+

$3.29 $2.95
HSS Screw Machine - Drills Size: 0.1575 In., 4.00 mm Flute Length: 7/8, 22 mm Overall Length: 2-5/32, 55 mm Finish/Coating: Black Oxide Point...
In Stock
+

$3.25
This drill is used for drilling holes for the 4.5mm rivet holes in the bent receivers as well as opening the hammer pin hole on my flats before reaming to...
In Stock
+

$37.95
This tool is made for removing the trunnion rivets off of parts kits or removing rivets that we sell.  Made of steel then heat treated for wear...
In Stock
+

$4.25
HSS Screw Machine - Drills Size: 0.1969 In., 5.00 mm Flute Length: 1-1/32, 26 mm Overall Length: 2-7/16, 62 mm Finish/Coating: Black Oxide...
In Stock
+

$25.00
Use this reamer for the .315 oversize barrel pins.  Start with the hole drilled at 7mm then switch to the reamer.
In Stock
+

$3.75
This drill is .076" and the original port size is .077". More than likely with a cheap drill press or hand drill the bit will cut oversize so it won't...
In Stock
+