Drills and Taps

$37.95
This tool is made for removing the trunnion rivets off of parts kits or removing rivets that we sell.  Made of steel then heat treated for wear...
In Stock
+

$32.45
 5mm and 7mm reamers for finishing the hammer and trigger holes on my flats. These will ensure that you have perfectly round holes for the axis pins to go...
In Stock
+

$25.00
This is the same reamer we use to work with the .302 barrel pin holes.  Drill the hole first with a 7mm drill then ream the hole.  The reamer has more...
In Stock
+

$25.00
Use this reamer for the .315 oversize barrel pins.  Start with the hole drilled at 7mm then switch to the reamer.
In Stock
+

$20.50
This die will fix damaged threads on gas pistons as well as put new threads on custom made pistons.
In Stock
+

$15.00
Die Starter for 14-1 LH 7.62x39 rifles.
In Stock
+

$12.95
12mm x 1.25mm tap for cleaning up the threads on the bolt carrier when installing a new gas piston. Made of high speed steel for long life.
In Stock
+

$10.95
This is used with our 12-1.25 dies sold on the website.
In Stock
+

$9.95
This drill bit is for drilling the large selector hole on the right side of the receiver. This makes the larger side of the keyhole.  Get our 7/32 drill...
In Stock
+

$5.25
US Made by Precision Twist Drill Screw Machine - Drills Size: 0.2756 In., 7.00 mm Flute Length: 1-11/32, 34 mm Overall Length: 2-29/32, 74 mm...
In Stock
+

$4.95
These are the drill bits I use for drilling 7.62 gas ports.  These will fit into the port and it will guide the drill.  Just press the gas block on first....
In Stock
+

$4.95
6mm screw machine drill bit. This is used for drilling the hole in the bottom of a reciever when installing the latch assembly for the triangle side folding...
In Stock
+