Drills and Taps

$37.95
This tool is made for removing the trunnion rivets off of parts kits or removing rivets that we sell.  Made of steel then heat treated for wear...
In Stock
+

$20.50
This die will fix damaged threads on gas pistons as well as put new threads on custom made pistons.
In Stock
+

$4.95
These are the drill bits I use for drilling 7.62 gas ports.  These will fit into the port and it will guide the drill.  Just press the gas block on first....
In Stock
+

$15.00
Die Starter for 14-1 LH 7.62x39 rifles.
In Stock
+

$10.95
This is used with our 12-1.25 dies sold on the website.
In Stock
+

$3.75
This drill is .076" and the original port size is .077". More than likely with a cheap drill press or hand drill the bit will cut oversize so it won't...
In Stock
+

$5.25
US Made by Precision Twist Drill Screw Machine - Drills Size: 0.2756 In., 7.00 mm Flute Length: 1-11/32, 34 mm Overall Length: 2-29/32, 74 mm...
In Stock
+

$4.50
This drill bit is for drilling the front edge of the keyhole for the selector on the right side of the receiver. US Made by Precision Twist Drill....
In Stock
+

$4.95
6mm screw machine drill bit. This is used for drilling the hole in the bottom of a reciever when installing the latch assembly for the triangle side folding...
In Stock
+

$4.25
HSS Screw Machine - Drills Size: 0.1969 In., 5.00 mm Flute Length: 1-1/32, 26 mm Overall Length: 2-7/16, 62 mm Finish/Coating: Black Oxide...
In Stock
+

$32.45
 5mm and 7mm reamers for finishing the hammer and trigger holes on my flats. These will ensure that you have perfectly round holes for the axis pins to go...
In Stock
+

$2.95
These are the same drills I use in the Rivet Drilling tool, drilling gas piston rivet holes and for drilling holes for the 4mm rivet holes in receivers....
In Stock
+