Drills and Taps

$2.95
Replacement drill bit for our milled receiver drilling fixture. Used to drill the selector stop hole and for drilling the trigger hole before...
In Stock
+

$4.95
6mm screw machine drill bit. This is used for drilling the hole in the bottom of a reciever when installing the latch assembly for the triangle side folding...
In Stock
+

$4.65
2.5mm Screw Machine Drill Bit
In Stock
+

$37.95
This tool is made for removing the trunnion rivets off of parts kits or removing rivets that we sell.  Made of steel then heat treated for wear...
In Stock
+

$15.00
Die Starter for 14-1 LH 7.62x39 rifles.
In Stock
+

$10.95
This is used with our 12-1.25 dies sold on the website.
In Stock
+

$3.75
This drill is .076" and the original port size is .077". More than likely with a cheap drill press or hand drill the bit will cut oversize so it won't...
In Stock
+

$20.50
This die will fix damaged threads on gas pistons as well as put new threads on custom made pistons.
In Stock
+

$2.85
Material: HSS Screw Machine - Drills Size: 0.1181 In 3.00 mm Flute Length: 5/8, 16 mm Overall Length: 1-13/16, 46 mm Finish/Coating: Black...
In Stock
+

$3.29 $2.95
HSS Screw Machine - Drills Size: 0.1575 In., 4.00 mm Flute Length: 7/8, 22 mm Overall Length: 2-5/32, 55 mm Finish/Coating: Black Oxide Point...
In Stock
+

$4.25
HSS Screw Machine - Drills Size: 0.1969 In., 5.00 mm Flute Length: 1-1/32, 26 mm Overall Length: 2-7/16, 62 mm Finish/Coating: Black Oxide...
In Stock
+

$4.95
These are the drill bits I use for drilling 7.62 gas ports.  These will fit into the port and it will guide the drill.  Just press the gas block on first....
In Stock
+