0 Cart

MAK90 Receiver Flat with Trunnion Holes

B5-21
MAK90 RECEIVER FLAT WITH TRUNNION HOLES, B5-21

MAK90 Receiver Flat with Trunnion Holes

$54.95

This is our MAK90 flat with trunnion holes and the top rails machined. 

Due to the dimensional differences between these and the other flats you will need to use a different punch for our die to bend these.  Originally the receivers were made from .057" material and these are made from .050" annealed 4130.  If you have already bought the bendind die from this website your user account should be activated to see the Chinese MAK90 punch for sale under the bending die category.

The internal dimension for the Chinese MAK90 receivers is 1.225" which is why a new punch will be needed.  The other punches we have sold in the past are 1.208 or 1.250.

Currently we do not have the center supports that are narrow enough for these, but you can cut a 1mm center support down in length.

For such a small run of flats we didn't have new magwell dimple dies made so these use the RPK rails which will make up for not having the dimples.

 

 

 

This item is made in the United States and counts as a 922r compliant part.

Receiver Thickness:
1.27mm
$37.95
This tool is made for removing the trunnion rivets off of parts kits or removing rivets that we sell.  Made of steel then heat treated for wear...
B6-31
In Stock

  • Out of stock
AK-Builder Rivet Tool
$270.00
THIS WILL INSTALL THE FRONT/REAR TRUNNION RIVETS AND CENTER SUPPORTS .  It will not install the trigger guard rivets. Are you ready for a...
T5-11
No products with the selected options in stock

$14.00
PSL/FPK
The new long rear trunnion rivets have a slightly shorter head and the cupped tool that supports the rivets will need to be sanded down to keep the...
A0-11
In Stock
 

No reviews found