0 Cart

Mak 90 Underfolder Flat With Magwell Dimples

B1-41
MAK 90 UNDERFOLDER FLAT WITH MAGWELL DIMPLES, B1-41

Mak 90 Underfolder Flat With Magwell Dimples

$58.95
THIS REQUIRES OUR MODIFIED MAK90 PUNCH TO BEND CORRECTLY. IF YOU USE OUR OLD PUNCH IT WILL RUIN THE FLAT! WE HAD TO MODIFY THE MAK90 PUNCH TO ACCOMADATE THE UNDEDRFOLDER STAMPING ON THESE FLATS. THE NEW PUNCH WE OFFER CAN BE USED ON ALL MAK90 FLATS THAT WE SELL.
 
How to tell if your Mak90 punch will work with this flat.
All of our flat bending die punches have a serial number on them. If the serial number on your Chinese Mak90 punch is "7310" OR GREATER then you have the proper punch for these flats. If your number is LESS THAN "7310" then you will ruin this flat if you bend it using the punch. The new modified punch must be purchased in order to bend these flats.

 

This is our MAK90 Under folder Type56-1 Receiver Flat.

Due to the dimensional differences between these and the other flats you will need to use a different punch for our die to bend these.  Originally the receivers were made from .057" material and these are made from .050" annealed 4130.  If you have already bought the bending die from this website your user account should be activated to see the Chinese MAK90 punch for sale under the bending die category.

The internal dimension for the Chinese MAK90 receivers is 1.225" which is why a new punch will be needed.  The other punches we have sold in the past are 1.208 or 1.250.

Currently we do not have the center supports that are narrow enough for these, but you can cut a 1mm center support down in length.

 

 

This item is made in the United States and counts as a 922r compliant part.

 

No reviews found