0 Cart

AK-Builder Flat Bending Die Set

DIE-SET
AK-Builder Flat Bending Die Set

AK-Builder Flat Bending Die Set

$284.95

 The base of this die set is made from a solid piece of steel that starts off at 17lbs and is machined to 14.5lbs.  There is a radius at the entrance of the die which takes less pressure to make the bend.  In my testing I have bent several flats by just putting the ram in the middle of the punch and pressing the flat straight in without moving the ram down the length of the punch.

Once the flat is pressed in there are set screws in the lower die that will be used to remove the flat and punch assembly from the lower die. This die set will NOT bend the upper rails into the receiver.

OUR MAK90 PUNCH HAS BEEN UPDATED AS OF OCTOBER 19TH 2018!! PLEASE MAKE SURE YOU HAVE THE PROPER MAK90 PUNCH BEFORE USING IT ON OUR NEW MAK90 UNDER FOLDER FLATS!

How to tell if your Mak90 punch will work with our new Mak90 Under folder Flats.

All of our flat bending die punches have a serial number on them. If the serial number on your Chinese Mak90 punch is "7310" OR GREATER then you have the proper punch for the new Mak90 under folder flats. If your number is LESS THAN "7310" then you will ruin the Mak90 under folder flat. You will need to place an order and purchase the new punch from here. If you already have one of our punch sets make sure you LOG INTO your account so that you can purchase the new punch.

 

Options:
MAK90 and 1mm Punch add $65
  • Out of stock
AK-Builder Barrel Press Kit
$132.45
1" Ram
Choose the ram size of your press in the drop down box below. The 1" and 1.6" ram pieces are machined on a lathe from bar stock then black oxided. ...
T6-11
 
No products with the selected options in stock

$85.00
This jig will install the five trigger guard rivets. The front four rivets can be set at once and the rear will be done separately. There is a magnet that...
T1-11
In Stock

  • Out of stock
AK-Builder Rivet Tool
$270.00
THIS WILL INSTALL THE FRONT/REAR TRUNNION RIVETS AND CENTER SUPPORTS .  It will not install the trigger guard rivets. Are you ready for a...
T5-11
No products with the selected options in stock

$29.95
Rail alignment fixture to install the lower bolt guide rails in stamped receivers. The rails clamp inside the fixture which inserts into the trunnion to...
C3-61
In Stock

$99.95
Here is a professional tool for drilling the front and rear trunnion holes in AK47 receivers.  This tool will work with 7.62 and 5.45 trunnions...
T3-11
In Stock

$36.95
 5mm and 7mm reamers for finishing the hammer and trigger holes on my flats. These will ensure that you have perfectly round holes for the axis pins to...
A2-31
In Stock

No reviews found