Welcome to ak-builder.com!

Ak-Builder 3mm Finish Pin Punch

N-12
Write a review
$9.95
In Stock
+
Add to wish list

This punch is used for the 3mm pins on standard gas blocks and front sights once it has started to move using another punch.  Using the long punch to start the pin to move can cause the punch to bend.

We designed these punches for demilling parts kits in our shop and use them daily. These can be bought as a set or individually. 

The problem with buying regular punches is that you have to cut them down to make a starter punch to get the 3mm and 4mm pins to start moving.  Once they start then punching them out the rest of the way with a longer punch usually is the easier part.  The punches have a hex head with an o-ring so you can use a 7/16" wrench to hold the punch without having to worry about hitting yourself when trying to get the pin started to move.

The punches are made of tool steel and heat treated then black oxided.  Be sure to wear eye protection when using any punch.

 

B6-51
$49.95
We designed these punches for demilling parts kits in our shop and use them daily. These can be bought as a set or individually.  The set comes with a 7/16"...
In Stock
+
Add to wish list

N-13
$9.95
We designed these punches for demilling parts kits in our shop and use them daily. These can be bought as a set or individually.  The problem with buying...
In Stock
+
Add to wish list

N-11
$9.95
This punch is used for the 3mm pins on standard gas blocks and front sights. We designed these punches for demilling parts kits in our shop and use them...
In Stock
+
Add to wish list

N-14
$9.95
This punch is used for the 4mm pin in the rear sight if it is still tight after using the starter punch. We designed these punches for demilling parts...
In Stock
+
Add to wish list

N-15
$9.95
This punch is used for the 4mm pin to drive it completely out of the rear sight.  It is best to use a starter length punch to get the pin to move otherwise...
In Stock
+
Add to wish list

No reviews found

Customers Also Bought