0 Cart

Heat Treated AK-Builder AK-74 5.45 x 39 1mm Non FFL Polish Tantal Receiver Blank

F1-11-FHT-POL
In Stock
$89.95
Add to wish list
HEAT TREATED AK-BUILDER AK-74 5.45 X 39 1MM NON FFL POLISH TANTAL RECEIVER BLANK, F1-11-FHT-POL

Heat Treated AK-Builder AK-74 5.45 x 39 1mm Non FFL Polish Tantal Receiver Blank

$89.95

Using our receiver flats, rails and center support these receivers are bent, rails trimmed and fully heat treated, then the rails are aligned and welded. We are leaving out the center supports to work with the older drilling fixtures.  All thats left to do is drill out the fire control group using our receiver blank drilling fixture and drill the trunnion holes using our trunnion hole drilling fixture.

For use with the Polish Tantal with the fire rate switch on the left side of the receiver.

YOU MUST USE A DRILLING FIXTURE MADE SPECIFICALLY FOR THE POLISH TANTAL ON THIS BLANK!  The selector holes are in a different location than a standard AKM receiver.

If you have bought our receiver blank drilling fixture you can see the new side plates that are made to drill the holes in these blanks.

 

 

This item is made in the United States and counts as a 922r compliant part.

 

Markings and Notches:
No Markings
$139.95
V-5 Standard or Underfolder-Sidefolder Plates
AK-BUILDER Receiver Blank Drilling Fixture This tool is designed to be used with 80% receivers with OR without rails and center supports...
T2-11
In Stock
 

$99.95
Here is a professional tool for drilling the front and rear trunnion holes in AK47 receivers.  This tool will work with 7.62 and 5.45 trunnions...
T3-11
In Stock

No reviews found