Welcome to ak-builder.com!

Romanian Underfolder 7.62x39 Parts Kit with Headspaced New 16" US Barrel

Write a review
In Stock
Add to wish list


This is a parts kit that was bought and we installed a new US made barrel.  We have options for non-chrome, chrome and nitrided barrels.  The picture of the parts kit was taken of a kit with a nitrided barrel.

 Keep in mind these kits are sold as is as far as furniture and finish are concerned.  I don't get to cherry pick the kits when we order them and I can't guarantee anything other than all of the parts except for the auto sear and rate reducer will be included. 

Ok, now that that is done here is what we've done...

All journals are measured as well as the parts to be pressed to make sure the fit is correct.  We set the headspace and check it twice with a GO gauge, with a live round (not fired just for testing the bolt closing) then with a NO-GO gauge.  After setting the headspace we drill the barrel pin hole and ream for the new barrel pin.  The pin is pressed most of the way through so you can press it back out the same way it was put in to remove the barrel for installing rivets.  If you don't want to use rivets then just press the barrel pin the rest of the way in.

The rear sight, gas block and front sight are pressed on after the barrel pin is installed to make sure everything fits correctly on the barrel.  We use a special fixture to press on each piece to ensure proper alignment.

When reinstalling the barrel I reccomend to use a headspace gauge again to make sure you install it back to the original setting. 

The parts kits come with just the main parts, no rivets and no tools.

The new long rear trunnion rivets have a slightly shorter head and the cupped tool that supports the rivets will need to be sanded down to keep the...
In Stock

These center supports will be less prone to crushing unlike other center supports made from steel tubing. There is nothing worse than having the center...
In Stock
Add to wish list

No reviews found