0 Cart

Romanian Fixed Stock 7.62x39 Parts Kit with Headspaced New 16" US Barrel

Kit-26N
In Stock
$709.95
Add to wish list
ROMANIAN FIXED STOCK 7.62X39 PARTS KIT WITH HEADSPACED NEW 16" US BARREL, KIT-26N

Romanian Fixed Stock 7.62x39 Parts Kit with Headspaced New 16" US Barrel

$709.95

THESE KITS HAVE ALL MATCHING NUMBERS.

Original military surplus parts kits.

This is a parts kit that was bought and we installed a new US made barrel.  Keep in mind these kits are sold as is as far as furniture and finish are concerned.  I don't get to cherry pick the kits when we order them and I can't guarantee anything other than all of the parts shown will be included.

Ok, now that that is done here is what we've done...

All journals are measured as well as the parts to be pressed to make sure the fit is correct.  We set the headspace and check it twice with a GO gauge, with a live round (not fired just for testing the bolt closing) then with a NO-GO gauge.  After setting the headspace we drill the barrel pin hole.  The pin is pressed most of the way through so you can press it back out the same way it was put in to remove the barrel for installing rivets.  If you don't want to use rivets then just press the barrel pin the rest of the way in.

The rear sight, gas block and front sight are pressed on after the barrel pin is installed to make sure everything fits correctly on the barrel.  We use a special fixture to press on each piece to ensure proper alignment.

When reinstalling the barrel I recommend to use a headspace gauge again to make sure you install it back to the original setting. 

The furniture will more than likely need to be refinished since all of the kits we received have very abused furniture. Some kits will NOT have the dong lower handguard.

The parts kits come with just the main parts, no rivets, no center support, no receiver flat, no rails and no tools.

$46.95
With Y & I Embossing, 1mm
The front and rear trunnion holes on these flats are pre-punched to help with the installation of the trunnions.  In some cases the front trunnion...
B2-61Y
In Stock
 

$44.95
With Y & I Embossing, 1mm
Now with Y & I embossing! These flats can be used for about any 1mm thick 7.62 receiver.  Without the trunnion holes you can put any rear...
B1-71Y
In Stock
 

$14.00
PSL/FPK
The new long rear trunnion rivets have a slightly shorter head and the cupped tool that supports the rivets will need to be sanded down to keep the...
A0-11
In Stock
 

$7.00
Based on the Bulgarian style center support these DO NOT HAVE THE FLAT on them. Other countries have a larger diameter center support with the...
A1-31
In Stock

No reviews found