Cart is empty
Romanian Underfolder 7.62x39 Parts Kit with Headspaced New 16" US Barrel
Kit-28nc
Please sign in so that we can notify you about a reply
Kits are Non Matching!
This is a parts kit that was bought and we installed a new US made barrel. We have options for non-chrome, chrome and nitrided barrels. The picture of the parts kit was taken of a kit with a nitrided barrel.
Keep in mind these kits are sold as is as far as furniture and finish are concerned. I don't get to cherry pick the kits when we order them and I can't guarantee anything other than all of the parts except for the auto sear and rate reducer will be included. Some kits will NOT have the dong lower handguard.
Ok, now that that is done here is what we've done...
All journals are measured as well as the parts to be pressed to make sure the fit is correct. We set the headspace and check it twice with a GO gauge, with a live round (not fired just for testing the bolt closing) then with a NO-GO gauge. After setting the headspace we drill the barrel pin hole. The pin is pressed most of the way through so you can press it back out the same way it was put in to remove the barrel for installing rivets. If you don't want to use rivets then just press the barrel pin the rest of the way in.
The rear sight, gas block and front sight are pressed on after the barrel pin is installed to make sure everything fits correctly on the barrel. We use a special fixture to press on each piece to ensure proper alignment.
When reinstalling the barrel I recommend to use a headspace gauge again to make sure you install it back to the original setting.
The parts kits come with just the main parts, no rivets and no tools.
No reviews found